INSTRUCTION MANUAL 1-800-547-5740 • Fax: (503) 643-6322 www.ueitest.com • email: info@ueitest.
Introduction Controls and Indicators The INF215 is perfect for frequent use in advanced or specialty application environments, where wide temperature ranges and superior optics are essential for use on targets at greater distances. A UV Worklight has been added to diversify the INF215’s use. This full-featured IR Thermometer is the most comprehensive and best-valued Infrared Thermometer on the market.
Operating Instructions Taking Measurements To take a temperature measurement using your INF185/215, you simply point the aperture at an object (with or without using the laser sighting) and pull the trigger. The object’s temperature will show up on the display and update at a rate of approximately 2 times per second. There will be a delay of approximately one-second between the time you initially pull the trigger and the time the display comes on.
Additional Features Perform this first Press and release the trigger to activate display first Press and release the trigger to use these functions Verify that the meter is in one of these modes In MIN, MAX, DIF, AVG mode In all modes Press to activate the following LOCK - Press the “ “ pushbutton for LOCK mode ON/OFF - This locks the IR measurement for up to 60 minutes SCALE - Press “ “ push-button to select ˚C or ˚F BACKL IGHT/WORKL IGHT Press the “ “ push-button for backlight function ON/OFF LASER -
Lens Care The sensor lens is the most delicate part of the thermometer. The lens should be kept clean at all times. Care should be taken when cleaning the lens using only a soft cloth or cotton swab with water or medical alcohol. Allowing the lens to fully dry before using the thermometer. Do not submerge any part of the thermometer in liquids. WARNING! Under NO circumstance should you expose batteries to extreme heat or fire as they may explode and cause injury.
INF185/215 Infrared Thermometer Limited Warranty The INF 185/215 is warranted to be free from defects in materials and workmanship for a period of three years from the date of purchase. If within the warra n ty period your instrument should become inoperative from such defects, the unit will be repaired or replaced at UEi’s option.
