Owner manual

Press this button momentarily to recall or stop viewing
logged readings and MIN/MAX readings. Press this button
for more than 1 second to start or exit “SETUP”.
The “
EXIT” function is activated in the “RECALL” and
“
SETUP” mode only.
Press this button momentarily to start or stop logging. Press
this button for more than 1 second to clear logged
readings.
To clear logged data press and hold until “ “ appears
in the lower display. To execute the clear press and hold
until “ “ appears.
The “
ENTER” function is activated in the “SETUP” mode
only.
Operating Instructions
Before Operating
1. Plug the thermocouple(s) into the input terminal(s).
2. Press “ “ to turn the instrument on. After 1 second, the
thermometer displays the first reading and its internal
temperature. If no thermocouple is plugged into the selected
input or the thermocouple is “
OPEN”, the display shows “----”.
1. How to Change Setup Options
Use “SETUP” to reset the thermometer or change the time units, time
settings, thermocouple type, Auto-Power-Off mode, logging interval,
and offset.
Entering and Exiting Setup
When the thermometer is in “SETUP” mode, the display always shows
“
SETUP”.
• Press “ “ for more than 1 second to start or exit “
SETUP”.
NOTE: The meter must be in normal operation mode.
(Not logging or displaying Min/Max/Avg values)
• Press “ “ momentarily or “ “ for more than 1 second
to exit “
SETUP”.
NOTE: Press “ “ or “ “ to scroll to the setup option
you want to change and then press “ “ to accept the
selected setup option.
5