User Guide

6
OVERVIEW
RANGE
SEL
Temp
A
True RMS
MIN/MAX HOLD
FAST
Low Z
V
Low Z
Apo
µA
mAµA
A
mA
10A
MAX
FUSED
400mA
MAX
FUSED
MAX
CAT IV
600V
CAT III
1000V
DM525
mV
°F°C
REL
Hz
Hz %
W
PF
0 10 20 30 40 50 60
LINK
C
B
D
E
A
I
L
M
N
O
P
Q
J
G
H
F
A. Worklight
B. Apo: Auto power off after 30 minutes of use. Press and hold the HOLD button while turning the meter on to disable Apo.
C. Digital Backlit Display
D. Bar graph: 24 segment, displays when in Low Z, Volts AC/DC, mV AC/DC, Ohms, Continuity, Diode, µA AC/DC,
mA AC/DC and Amp AC/DC modes.
E. Range Button:
• Press to change from auto ranging to manual ranging.
• Press repeatedly to select proper range.
• Press and hold to return to auto range (AT will be displayed on screen).
F. Min/Max Button:
• Press to enter MAX/MIN mode.
• In the V, μA, mA or Amps function, either select AC/DC or change to manual ranging before pressing this button to
enter MAX/MIN mode.
• Press repeatedly to alternate between Maximum and Minimum readings.
• Press and hold to return to live readings.
G. Select Button:
•Press to select AC or DC or Auto Selection in the following functions: Voltage, µA, mA, Amps,
•Press to select Hz/Duty Cycle, DCmV/ACmV/°F/°C, Ohm/Continuity/Diode check/Capacitance or W/VA/VAr/PF.
H. Function Dial: Turns on meter and is used to select the function.
I. Hold/Fast Button:
• Press to hold the reading on the display. Press again to return to live reading.
• Press to enter Fast MAX/MIN mode in MAX/MIN mode.
• Press again to return to normal MAX/MIN mode.
J. Back Light/Worklight Button: Press to on back light. Press again to turn off. Press and hold to enable wireless
capability. Back light / Worklight duration is 1 minute.
K