Owner manual

4
batterieS replaCemeNt
This meter has been designed for use with alkaline batteries.
No other types of batteries are recommended. The analyzer is
supplied with 4 “AA” size alkaline batteries. These should be
installed into the instrument as shown in the diagram to the
right and indicated on the back of the unit.
CAUTION!
Take great care when installing the batteries to observe correct
polarity. Always check the meter for operation immediately
after installing new batteries.
eleCtromagNetiC Compatibility (emC)
This product has been tested for compliance with the
following generic standards:
 EN50081-1,EN50082-1andiscertifiedtobe
compliant.
TheEuropeanCouncilDirective89/336/EECrequiresthatelectronicequipmentdoesnotgenerateelec-
tromagneticdisturbancesthatexceeddefinedlevelsandhasanadequatelevelofimmunitytoenableittobe
operated as intended.
Sincetherearemanyelectricalproductsinusethatpre-datethisDirectiveandmayemitelectromagnetic
radiationinexcessofthestandardsdefinedintheDirectivetheremaybeoccasionswhereitwouldbeappro-
priate to check the analyzer prior to use. The following procedure should be adopted.
 •Gothroughthenormalstartupsequenceinthelocationwheretheequipmentistobeused
 •Switchonalllocalizedelectricalequipmentthatmightbecapableofcausinginterference
 •Checkthatallreadingsareasexpected(alevelofdisturbanceinthereadingsisacceptable)
 •Ifnot,adjustthepositionoftheinstrumenttominimizeinterferenceorswitchoff,
  ifpossible,theoffendingequipmentforthedurationofthetest
Atthetimeofwritingthismanual(August2011),UEiisnotawareofanyfieldbasedsituationwheresuch 
interferencehaseveroccurredandthisadviceisonlygiventosatisfytherequirementsoftheDirective.
Note: Follow battery directions
on back of housing
Battery Compartment
Cover
Back of
Instrument