Manual

batterieS rePlaCemeNt
This meter has been designed for use with both alkaline
 andrechargeableNickelMetalHydride(NiMH)batteries.
No other types are recommended. The analyzer is supplied
with 4 “AA” size alkaline batteries.
These should be installed into the instrument as shown
in the diagram to the right and indicated on the back of
the unit.
CAUTION!
Take great care when installing the batteries to observe
correct polarity. Always check the meter for operation
immediately after installing new batteries.
uSiNg re-Chargeable batterieS
 ThebatterychargermustonlybeusedwhenNiMHbatteriesarefitted.Alkalinebatteriesare not
re-chargeable. Attempting to recharge alkaline batteries may result in damage to the product and may
create a fire risk.
battery ChargiNg
 Ensurethatyouusethecorrectcharger.Thisunitusesa9VDCregulatedcharger.
 Ensurethatthebatteriesarefittedinthecorrectmanner,andthenchargeforatleast16hours.Subsequent
 chargesshouldbeovernight.NiMHbatteriesmaybechargedatanytime,evenforshortperiodsto
conduct testing.
WARNING!
Under NO circumstance should you expose batteries to extreme heat or fire as they may explode and cause
injury. Always dispose of old batteries promptly in a manner consistent with local disposal regulations.
eleCtromagNetiC ComPatibility (emC)
 Thisproducthasbeentestedforcompliancewiththefollowinggenericstandards:
 EN50081-1,EN50082-1andiscertifiedtobecompliant.
 TheEuropeanCouncilDirective89/336/EECrequiresthatelectronicequipmentdoesnotgenerate
 electromagneticdisturbancesthatexceeddefinedlevelsandhasanadequatelevelofimmunitytoenableitto
be operated as intended.
 Sincetherearemanyelectricalproductsinusethatpre-datethisDirectiveandmayemitelectromagnetic
radiation in excess of the standards defined in the Directive there may be occasions where it would be
appropriate to check the analyzer prior to use. The following procedure should be adopted.
  •Gothroughthenormalstartupsequenceinthelocationwheretheequipmentistobeused
 •Switchonalllocalizedelectricalequipmentthatmightbecapableofcausinginterference
  •Checkthatallreadingsareasexpected(alevelofdisturbanceinthereadingsisacceptable)
 •Ifnot,adjustthepositionoftheinstrumenttominimizeinterferenceorswitchoff,ifpossible,the
  offendingequipmentforthedurationofthetest
 Atthetimeofwritingthismanual(July2006)UEiisnotawareofanyfieldbasedsituationwheresuch 
 interferencehaseveroccurredandthisadviceisonlygiventosatisfytherequirementsoftheDirective.
Note: Follow battery
directions on back of
housing
Battery Compartment
Cover
Back of
Instrument
4 5
C75 Directions
C125/C127 Directions
OR