User Manual

3.PointtoMultipointPairingStep:
1masterbridgewith3slavebridges
1.SwitchoneunittoA(MasterBridge)and3unitstoB(SlaveBridge);
2.ConnectthePOEtoeachunitusingtheEthernetcableandplugthePOEin;
3.Waitforthemtopowerup,about2min;
4.Usethetinyresetbuttontoclickthroughuntilyougetachannelwithaletter.
1,2,3,...,A,B,C,...,F,hereusedC;
5.Thenontheother3unitdothesame.4unitsneedtobeonthesamechannel;
6.Waitfor2-5minutestocompletethepairing.Whenthenumberofthedigital
tubeissolidandthesignallightonthesideturnson,itmeanstheirpairingis
successful;
7.Finallyconnectotherdevices(Router,PC,Switch)andinstallthemtothe
targetlocation.
4.Installation
1.PlacetheCPEtotheselectedpositionandadjusttheCPEfrontpanel
orientationtobeapproximatelythesameastheselecteddirection,thenuse
thetiestofixtheCPE,thebracketisnotincludedinthepackage.
RecommendedUeeViiUniversalBracket(ASIN:B09NLLG8MZ).
2.Please,preparealongenoughnetworkcabletoconnectthePoEadapter
andCPE,thenetworkcableisconnectedtotheLANportoftheCPE,andthe
otherendisconnectedtothePoEportofthePoEadapter.Recommendto
useacat5(orabove)shieldednetworkcablewithagroundwire.
A B
06
[e-mail]