Owners Manual

97
 I’d like to set pause.
 Refer to [Option menu].
 I’d like to indicate cleaved angle, fiber angle and clad deviation.
 Refer to [Option menu].
 Estimated splice loss and measured splice loss does not match.
 The estimated splice loss is a calculated value so it should be used
only as a reference.
9.3 Sleeve heater
 Fiber protecting sleeve is not contracted completely.
 Increase the heating time. Refer to [Heater mode edition].
 Heater is overheated.
 Stop the heater by pressing , turn the power off and then
contact Ilsintech.
 If the protecting sleeve melts and it sticks to the heater cover,
remove it by pushing it with a cotton swab.
 I’d like to initialize heater mode’s heating condition.
 Refer to [Heat mode edition].
 I’d like to cancel heater in the middle of operation.
 Heater operation cannot be canceled by pressing . Cancel it by
pressing once again.
9.4 Others