Owners Manual

95
 Charge the battery.
 Remaining battery is not well displayed.
 Remaining battery display is for reference.
9.2 Splice
 Error message is displayed on the screen.
 Refer to the [Error message list].
 Splice loss is high or irregular.
 Clean V-Groove, V-Block, reflector and object lens by referring to
[Maintenance of splice quality]. Replace electrodes by referring to
[Electrodes replace]. Refer to the “High estimated loss” from [Error
message list].
 If fiber warps or is bent, place the fiber bent direction to face the
bottom. Splice loss varies depending on cleaving angle, arc condition
and cleanliness level of fiber. Splice loss is still high or irregular even
after implementing the above recovery measures, contact to
Ilsintech. Annual maintenance is required to keep splice optimal
quality.
 Monitor is suddenly turned off.
 Refer to [Monitor sleep mode menu].
 Power is suddenly turned off.
 Refer to [Splicer sleep mode menu].
 Either arc amount or arc time cannot be changed.
 On SM, NZ, MM or AUTO mode, either arc amount or arc time cannot
be changed. Implement [Arc Calibration], and the arc amount on