Owners Manual

90
7.5 Loss Limit Over.
It is an error message generated when the estimated loss value is bigger than the
preset loss factor limit.
Solution: Check the loss factor limit.
7.6 Fiber Thin Error
It is an error message generated when the spliced point becomes thinner than the
standard after splicing.
Solution: Make an adjustment to shorten the pulling length of the pulling splice. Check
whether the arc amount or arc time is set as too large or too long respectively.
7.7 Fiber Thick Error
It is an error message generated when the spliced point becomes thicker than the
standard after splicing.
Solution: Reduce the overlap set value. Check whether the arc amount or arc time is
set as too small or too short respectively.