Owners Manual

89
7.3 Too Long Fiber.
It is an error message generated when the fiber is located too close to the electrodes;
object lens or reflector is dirty or the LED is not sufficiently bright enough.
Solution: Press and put the fiber on a right location yet again. Clean the object
lens and reflector. Conduct LED test. If an error occurs upon performing the LED test,
contact Ilsintech.
7.4 Fiber Over Angle
It is an error message generated when the cleaved angle of the fiber is measured as bigger
than the limit.
Solution: Check the state of the fiber cleaver. Check the cleaved angle limit.