Owners Manual

54
Taper Wait
It designates the time period from the last
of the advanced fiber amount to the
beginning of pulling.
Taper Speed It sets the fiber pulling speed.
Taper Length It sets the fiber pulling time.
Editable
Offset
It is the sum of the initially measured
splice loss value and the increased loss.
When splicing a special fiber or other
fibers, high loss may be incurred in spite of
optimum arc conditions. To match the
estimated splice loss and the actual splice
loss, the minimum value of actual splice
loss should be set.
6.1.5 Selection
Press and the selected splice mode is saved on memory and it is used upon
splicing.
6.1.6 Close
Press and it goes back to the previous stage.