Owners Manual

51
[Set values editable within mode]
Set value Description
General
mode
User
mode
Fiber Type
Displays the list of splice mode that is
saved on the splicer data to facilitate the
selection of a proper mode for use.
Among splice modes saved on the
database, it copies a similar splice mode to
use an editing function.
Editable
Editable
Mode Title
Mode title 1 is for indicating splice mode
within 11 characters at a maximum.
Auto Power
The closer fibers are aligned to the core
center with a fewer number of errors, the
quicker and better the arcing is done.
Uneditab
le
Proof Test Conducts tensile force test after splice.
Cleaved Limit
Sets the cleaved angle’s error limit.
Editable
When either of the cleaving angles on both
fibers are outside the limit., an error
message is displayed.
Loss Limit
Sets the estimated loss value’s error limit.
When estimated loss is higher than the
limit, error message is displayed.
Fiber Angle
Limit
When the bending of 2 spliced fibers
exceeds the set limit, an error message is
displayed.
Uneditab
le
Cleaning
Power
A short arc cleaning is conducted to
remove fine dust on the fiber surface upon
initial stage of fiber alignment. It sets the
intensity of the cleaning arc.
Editable
Cleaning Time It sets the time for the cleaning arc.
Editable
Gap
Upon final alignment, it sets the clearance
of the cross section between both fibers.