Owners Manual

35
5.2.2 Electrodes replacement
It is recommended to replace the electrodes after using appx 3,000 times. If the
number of arc exceeds the replacing cycle, a message for electrodes replacement is
displayed on the screen. Without electrodes replaced splice loss increases and the
tensile force at the splicing point weakens.
i. Turn the power off when replacing the electrodes.
ii. Open the wind cover and unscrew the clamp screw of the electrodes block.
iii. Remove the electrodes block and the electrodes.
iv. Clean the electrodes carefully by using a soft cotton swab moisten by alcohol,
then install it.
v. Turn the power on and conduct electrodes stabilization process in the menu.