Owners Manual

30
4.10 Removing the spliced fiber
i. Open the cover of the sleeve heater.
ii. Open the wind cover.
iii. Hold the fiber on the left and open the clamp on the left.
iv. Open the fiber clamp on the right.
v. Hold both sides of spliced fiber and separate the fiber from Swift KF4A
with care.
4.11 Heating protection sleeve
i. Move spliced point to the center of the protecting sleeve. Place the protected
pin in the sleeve with face down.
ii. Place the protecting sleeve at the center of sleeve heater.
iii. Hold and put down the both fibers as shown in the figure then the heater
cover will automatically close.
iv. Heating starts by pressing .
v. LED is turned off when heating is completed.
vi. Open the heater cover and take out the fiber. Do not touch the protecting
sleeve or heater at any point during or right after heating.
vii. Conduct a final inspection on whether there are bubbles, fragments or any
dust on the sleeve.