Owners Manual

25
iii. Turn the wrench bolt; put it in Cam Pin and then remove it from the slider by
pulling with a tweezers, etc.
iv. Pay special attention in order to prevent blade damage while replacing it.
Assembly is done in reverse order of disassemble and the set screw should be
firmly tightened.
4.7.4 Blade height adjustment
i. Insert a wrench in the bottom of cleaver as in the figure and properly unscrew
the set screw of slider. Slider should be back warded.
ii. Turn the Cam Pin with flat - headed screwdriver to adjust the blade’s height.
Turning clockwise : Blade going up
Turning counterclockwise : Blade is going down