Owners Manual

18
Use ethyl alcohol with a purity level of 96% or higher.
i. Heater warms up. Make preparations by opening up the heater cover and slide
cover.
ii. Install fiber to be stripped on the holder as in the figure. The minimum
stripping length is 18mm.
iii. Place the holder with fiber on the holder base and close the cover.
iv. When the heater cover is closed, the fiber heats up for the preset time period
and the slider moves to the left to strip the fiber.
v. When stripping is completed, open the slide cover and remove the holder.
Opening up the heater cover will call back the slider automatically and get
ready for the next stripping.
vi. For the next procedure, remove the stripped sheath residue from the heater
and blade parts using a soft brush, etc.
Handle the blade part with care because it is easy to be contaminated and
deformed.