User's Manual

pressed. Note that the position and size of Pen Area may vary if you
have modified it on The Scope Configuration Page.
6. However, before Tablet Driver is properly installed, moving Pen Tip
or the Mouse over Tablet Plate will not cause the cursor on the screen
to move.
Changing the Battery
After you have used the Pen Device normally for a while, and the Device begins to
work sluggishly, or does not work at all, the battery may be running low or out.
You may follow the steps below to change the battery in the Pen.
1. Gently slide off the end cap of the Pen. Do not turn, as there
are no threads.
2. Insert a new battery (1.5V, size AAA) with the end marked
with minus (-) sign facing Pen Tip.
3. Slide the end cap back in.
Verifying Overall Installation
After both hardware and Driver and Pen Utilities are installed, you may follow the
procedures in this section to verify that both the Tablet hardware and Tablet Driver are
functioning properly. You may also follow these procedures at any time when you
suspect the system may be malfunctioning.
Verifying General Functionality
1. When you move Pen Tip or Mouse over Tablet Plate, the cursor will move
over the screen accordingly. However, the Pen and the Mouse behave
differently. The Pen acts in what is known as Absolute Mode. That is,
when you put the Pen at the upper left corner of the Plate, the cursor will be
at the upper left corner of the screen; when you move the Pen to the center of