User's Manual

Verifying Hardware Installation
Verify that the Pen Device hardware functions properly by following the procedure
described in this section.
The green LED light is the key indicator for hardware verification. Watch it as you go
through the test procedure. If the light does not come on at all, see the following table
for suggested action to take.
If the LED light does not come on...
Possible Cause Suggested Corrective Action
Cable connections are loose or incorrect, so that the
Pen device does not get power.
Go through the installation procedure again and correct
the connections.
The Cordless Pen or Mouse has gone to "sleep" to
conserve its battery power.
Tap the Pen on any surface or press the Left Button to
"wake it up".
The battery in the Cordless Pen or Mouse is out. Change the battery.
The LED light or some other part of the Pen Device is
defective.
Go to the place where you bought your Pen Device and
seek help there.
Hardware Verification Procedure
1. The green LED light on Tablet Plate will come on briefly as soon as
Tablet Plate receives power, and will stay off as long as Pen Tip or
Mouse is not above Pen Area in Tablet Plate, or it is too high above
the Plate.
2. Tap the Cordless Pen on any surface or press the Left Button of the
Mouse to "wake it up". You need not do this for a Corded Pen.
3. The LED light will flash slowly when Pen Tip is directly above Pen
Area of Tablet Plate and is low enough to be detected by Tablet Plate,
or when the Cordless Mouse rests in the Pen Area.
4. For as long as you press a Barrel Button on the body of the Pen or
any of the Mouse Buttons, the LED light will be on.
5. When you press Pen Tip against Tablet Plate anywhere in Pen Area,
or press the Left Mouse Button while the Mouse is in Pen Area, the
light will also be on as long as the Tip or the Button remains