User's Manual

1. Attach the hardware to your computer according to its type (Pen Device with
USB Interface, Pen Tablet with RS232C Interface, or Tablet Keyboard with
RS232C Interface),
2. Verify
that hardware is installed properly,
3. Install the Driver and Pen Utilities
, and
4. Verify
that the pen device as installed functions properly.
5. Install optional Application Software according to its own instructions (not
included in this manual). Most Application Software is installed by running
its Setup program.
Installing Pen Device with USB Interface
To attach the Pen Device with USB interface to your computer, first locate an
available USB Receptacle on the computer, usually on the back panel, on the monitor,
or on the keyboard. Then, plug the USB Connector into the Receptacle, in a way
similar to the figures shown below. On a computer system that fully supports USB
interface, there is no need to turn off the power, nor restart the operating system.
The Pen Device may be either a Pen Tablet or a Tablet Keyboard.
When the system detects the presence of a USB Pen Device, it will attempt to look for
its driver. Please select Cancel or press the escape key (marked Esc) to get out of it,
and start the Setup program on the Driver Disc to install the Driver and Pen Utilities.
If a USB Pen Device has been installed before, and the driver has not been uninstalled,
the operating system will automatically find the installed driver when you re-attach a
Pen Device, and you need not run the Setup program again unless you wish to
upgrade Driver Program.
After the Driver and Pen Utilities is installed, please verify
that the Pen Device
functions properly.
The optional Cordless Mouse needs no special instllation, and will start to function
normally as soon as Pen does.