User's Manual

Figure 56 The PenSigner Expanded Toolbar
When you draw anywhere on the screen, the Pen leaves a trace just like a regular pen
does. PenSigner keeps track of each stroke that you draw. When you press OK
Button, PenSigner first emulates an Edit/Copy (Control-C) to insert the entire
drawing into system Clipboard, and then emulates an Edit/Paste (Control-V) to copy
the drawing into Target Window.
Target Window is the window that was last active right before you tapped OK Button.
NOTE: Similar to a real pen, the "ink" in Pen or Brush is limited. When the "ink"
runs out, you must tap OK Button to complete the drawing or tap Cancel Button
before you can draw more pictures.
Functions of Buttons on PenSigner Toolbar
• System Button
When you tap on System Button, you will see this menu drop
down:
. If you select Settings, some selections appear (see
below) to allow you to alter the behavior of PenSigner; if you select About, an
information page appears; if you select Close, the Toolbar disappears and
PenSigner goes away.
• Settings Page
When you tap on System Button, and then select Settings, the following page
appears.
Figure 57 Settings Page
If you check "Auto Send after Timeout", PenSigner will send out the
drawing automatically after you pause for the time indicated on the
right (in milliseconds). Un-Checking it will cause PenSigner to wait
until you tap on OK Button before sending out the drawing.
If you check "Send then close this appl", PenSigner will automatically
close the PenSigner Toolbar after the drawing is sent.