User's Manual
Table Of Contents
- FEDERAL COMMUNICATIONS COMMISSION
- General Information
- Installing Hardware
- Installing Driver and Pen Utilities
- Verifying Hardware Installation
- Verifying Overall Installation
- Usage Tips
- Pen Scrolling
- Configuring the Pen Device
- Pen Utilities
- Annotate for Word V2.0 Program
- PenMail V1.0 Program
- PenSigner V2.0 Program
- Annotate All V1.0 Program
Figure 12 The Button Configuration Page
Note: When you configure the Pen Tip and Barrel Buttons, the buttons of the
Cordless Mouse are also automatically configured. Namely, the Left Mouse Button
will take up the definition for the Pen Tip, the Middle Mouse Button for Barrel Button
1, and the Right Mouse Button for Barrel Button 2.
• Mode
Absolute: When you move the Pen over Pen Area on Tablet Plate, the cursor
on the screen moves instantly with it. In the Absolute Mode, the points in Pen
Area on Tablet Plate correspond directly in position to the points on the screen.
Most people prefer this mode when using a Pen Device.
Relative: In this rarely used mode, when you move the Pen over Tablet Plate,
the cursor moves relatively to the starting position when the moving stroke
started, in a way similar to using a mouse. To complete a stroke, either move
the Pen upward until the Plate no longer detects the Pen or take the Pen out of
Pen Area. This setting is not recommended for normal use.
• Barrel Buttons
The numerals 1 and 2 indicate where Barrel Button 1 and Barrel Button 2 are,
respectively, on the body (barrel) of the Pen.
• Button Command