User's Manual

Mouse is not above Pen Area in Tablet Plate, or it is too high above the
Plate.
2. Tap the Cordless Pen on any surface or press the Left Button of the
Mouse to "wake it up". You need not do this for a Corded Pen.
3. The LED light will flash slowly when Pen Tip is directly above Pen
Area of Tablet Plate and is low enough to be detected by Tablet Plate,
or when the Cordless Mouse rests in the Pen Area.
4. For as long as you press a Barrel Button on the body of the Pen or any
of the Mouse Buttons, the LED light will be on.
5. When you press Pen Tip against Tablet Plate anywhere in Pen Area, or
press the Left Mouse Button while the Mouse is in Pen Area, the light
will also be on as long as the Tip or the Button remains pressed. Note
that the position and size of Pen Area may vary if you have modified it
on The Scope Configuration Page
.
6. However, before Tablet Driver is properly installed, moving Pen Tip or
the Mouse over Tablet Plate will not cause the cursor on the screen to
move.
Changing the Battery
After you have used the Pen Device normally for a while, and the Device begins to
work sluggishly, or does not work at all, the battery may be running low or out. You
may follow the steps below to change the battery in the Pen.
1. Gently slide off the end cap of the Pen. Do not turn, as there are
no threads.
2. Insert a new battery (1.5V, size AAA) with the end marked with
minus (-) sign facing Pen Tip.
3. Slide the end cap back in.
Verifying Overall Installation
After both hardware and Driver and Pen Utilities are installed, you may follow the
procedures in this section to verify that both the Tablet hardware and Tablet Driver
are functioning properly. You may also follow these procedures at any time when
you suspect the system may be malfunctioning.
Verifying General Functionality
1. When you move Pen Tip or Mouse over Tablet Plate, the cursor will move
over the screen accordingly. However, the Pen and the Mouse behave
differently. The Pen acts in what is known as Absolute Mode. That is, when