User's Manual

I. General Information

1-2

Verifying Hardware and Driver Functions

Please follow the steps to verify if the wireless tablet is installed properly︰

The green LED light on the Wireless tablet is the main indicator for hardware operation

and depending on your pen Wireless tablet model may be located at a different place that

shown in the above diagram. This LED normally stays off, and will only turn it on or off in

response to various conditions. Watch the state of the LED on the Wireless tablet as you

go through these test steps :

1. Tap on any surface with the tip of the pen, or press the left button of the mouse, to “wake it

up” if it has gone into standby mode. A built-in power saving function may have forced the pen

or mouse into the standby mode if either of them is not used for a period of time.

2. As soon as the pen Wireless tablet itself activates, the LED will be light briefly, and will then

go and stay off again.

3. When the Wireless tablet detects the presence of the digital pen or mouse, the LED will be

blinked slowly. This happens either when pen tip is hovering or placing within the working

area which above the Wireless tablet.

4. When you press a button on the pen barrel, or click on a mouse button, the LED will be

lighted up.

5. Hovering and moving the pen or the mouse in the working area will cause the cursor on the

screen to move accordingly.

★ Note: After the Wireless tablet’s (Media Wireless Tablet) device driver has been

properly installed, a small tablet icon ( ) will appear in the system tray, which is

normally at the lower right corner of the screen.

7. Usage Tips

7.1 Wake up the digital mouse from the standby mode

If the digital mouse does not react after you do not use it for a while, press the left button to “wake” it up from

the standby mode.

★Wireless Tablet (Media Wireless Tablet) can’t support digital mouse。

7.2 Tapping before you use the digital pen

Before you use the digital pen, or after not using it for several minutes, tap the pen on any surface of the

tablet to “wake” it up from the standby mode.

1- Express Key

2- LED Indicator

3- Digital pen slot

4- Working Area

5- Dongle

6- Button 2

7- Button 1

8- Pen tip

9- Power switch

10- USB Port (For power only)

11- Battery slot

12- Dongle slot

13- Resume button