User manual

You can program the robot to create new movements with PC software designed for Alpha 1S.The
PC software can be downloaded from the "Service & Technology" page of the UBTECH Robotics
website http://www.ubtrobot.com.
For software user manual and other technical support ,please go to "Service & Technology" page of
http://www.ubtrobot.com.
Action Program Run:
When Alpha is powered on, unplug the USB cable after the action program has been downloaded.
Turn on Bluetooth of a mobile phone and connect it to Alpha through the app. Click an action of the
app's “Action List” to execute the action program just downloaded.
Prompt:
1. Several robots can be controlled simultaneously with iOS client end;
2. You can edit various actions for the robot usingaction editing software on the PC end.
Note:
Before pressing "Reset/Start", please keep Alpha away from your face and eyes. In addition, do not
insert your fingers or any other objects into Alpha's joints. Please shut off the power immediately
when he is not in his normal operating state. In addition, do not place Alpha on the edge of anything
high as to prevent him from falling down and being damaged.
05 Troubleshooting
1. After starting and reset, some individual joints of the robot cannot work
A: The wires of some servo might becomeloosened or short-circuited. Detect whether the wires
of the servo are connected or worn;
B: Whether the servo gives out a "buzz" sound of the motor rotating. If yes, it needs to be fixed.
2. After connecting to the computer, the robot cannot be controlled or download programs
A: The contact between the download wire of the robot with the port becomesloosened. It needs
to be re-inserted or replace the USB data line;
B: The program of the robot has crashed, please restart it and download again;
C: The battery is has too little power left, recharge it first;
D: The format of the program is incorrect. Modify the format of the program by referring to the
format of the case offered with the machine.
3. After downloading the program, the robot cannot work normally
A: A grammar problem in the program;
B: The battery has too little power left, please recharge it first;
C: The wires of some servo might be loosened or short-circuited, detect whether the wires of the
servo are connected or worn.
4. The robot has sound, but does not move
A: Please check whether the plug of connection wires all over the robot has becomeloosened, or
the connection wires do not connectwell.
5. After the robot is started and reset, some servos remainsoft
A: The robot is out of power. Please turn it off and recharge it.