User's Manual

350-Watt Digital VHF LB Transmitter Chapter 3, Installation and Setup Procedure
DT325B, Rev. 0 3-11
Table 3-10: Menu 30-1 – System Details Screen
This is first screen of the details screens. The ↓ and ↑ arrows allow you to scroll through the
different parameters of each device as shown in Table 3-11. Each System Component is a
different screen. The proper modules will be programmed for your system.
Table 3-11: Transmitter Device Parameters Detail Screens
System
Component Parameter Normal
Faulted
(Blinking)
D/C PIN ATTEN VOLTAGE ˜.6V N/A
OVERDRIVE FAULT ˜1.6V N/A
AGC MODE AUTOMATIC N/A
ADAPTIVE EQUALIZATION
STATUS RUNNING N/A
MEASURED SIGNAL TO NOISE ˜32.6dB N/A
PLL STATUS LOCKED N/A
SMTE310 INPUT STATUS OK N/A
DEMOD FUNCTION STATUS OK N/A
FX VERSION ˜1.013 N/A
Axciter Details
NB VERSION ˜0.029 N/A
D/C PIN ATTEN VOLTAGE ˜0.0 N/A
U/C PIN ATTEN VOLTAGE ˜1.6V N/A
AFC 1 LEVEL ˜0.06V N/A
INPUT STATUS OK N/A
OUTPUT STATUS ON N/A
AGC 1 LEVEL ˜0.32V N/A
AGC 2 LEVEL ˜0.00V N/A
PLL XXXMHz N/A
PLL STATUS OK FAULT
OVERDRIVE LEVEL STATUS OK FAULT
Upconverter
Details
CODE VERSION 1.6h or higher N/A
System Control
Details
SUPPLY ENABLED FOR xxx HOURS N/A
Pushing the ↓ Down Arrow, after scrolling through all of the detail screens, will put you
back to Menu 30, Table 3-9. Push the ESC button to exit the Transmitter Device
Parameter Screens to Menu 12, Table 3-6, the Transmitter Device Parameter Access
Screen.