User's Manual

Innovator CU250ATD, 250 Watt Transmitter Introduction
Instruction Manual, Rev. 0 1
Manual Overview
This manual describes the transmitter, along with the setup and alignment procedures
for the transmitter.
Assembly Designators
Axcera has assigned assembly numbers, Ax designations such as A1, where x=1,2,3…etc,
to all assemblies, modules, and boards in the system. These designations are referenced
in the text of this manual and shown on the block diagram and interconnect drawings
provided in the appendix.
The cables that connect between the boards within a tray or assembly and that connect
between the trays, racks and cabinets are labeled using Brady markers. Figure 1 is an
example of a Brady marked cable. There may be as few as two or as many as four
Markers on any one cable. These Brady markers are read starting furthest from the
connector. If there are four Brady Markers, this marker is the transmitter number such
as transmitter 1 or transmitter 2. The next or the furthest Brady Marker is the rack or
cabinet number on an interconnect cable or the board number within a tray. The next
number on an interconnect cable is the Tray location or number. The Brady marker
closest to the connector is the jack or connector number on an interconnect cable or the
jack or connector number on the board within a tray.
Figure 1: Brady Marker Identification
Drawing
Safety
The transmitter systems manufactured by Axcera are designed to be easy to use and
repair while providing protection from electrical and mechanical hazards. Please review
the following warnings and familiarize yourself with the operation and servicing procedures
before working on the transmitter system.
Read All safety Instructions – All of the safety instructions should be read and
understood before operating this equipment.
Retain Manuals – The manuals for the transmitter should be retained at the transmitter
site for future reference. Axcera provides two manuals for this purpose; one manual can
be left at the office while the other can be kept at the site.
Heed all Notes, Warnings, and Cautions – All of the notes, warnings, and cautions
listed in this safety section and throughout the manual must be followed.
Follow Operating Instructions – All of the operating and use instructions for the
transmitter should be followed.
Cleaning – Unplug or otherwise disconnect all power from the equipment before cleaning.
Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning.