User's Manual

Innovator CU5-1800BTD/BRD ATSC Transmitter/ Initial On Site
Regenerative Translator Turn On Procedure
Instruction Manual, Rev. 0 25
Push and release the ENTER button again and the ENTER BUTTON SETS TO CHANGE
MODE screen is displayed. Push and release the ENTER button again and the first set
up menu, which is the SET UP MENUS OF CHASSIS VALUES screen is displayed. Push
and release the DOWN Arrow button until the SET UP 8VSB DEMODULATOR screen is
displayed. Push and release the ENTER button to display the submenus under the SET
UP 8VSB DEMODULATOR menu. Push and release the DOWN Arrow until the 8VSB
DEMODULATOR USE OFF AIR CHxx is displayed. Push and release the ENTER button
and the XX, which indicates the Channel Number, will blink. Push and release the UP
or DOWN Arrow button until the new channel number is displayed. Push and release
the ENTER button, and the PUSH ENTER TO ACCEPT CHANGES menu is displayed.
Push and release the ENTER button again to accept the changes made. Push and
release the LEFT Arrow to exit to the SET UP 8VSB DEMODULATOR screen. Push and
release the LEFT Arrow again to exit to the SYSTEM SET UP Main Menu. Push and
release the UP or DOWN arrows to browse the main menus.
The following screens are typical of an operating system. The values indicated on the screens
in your system may vary from these.
Operation Screens
NOTE: The following Operation screens provide operating information only. No adjustments
are available using these screens.
Table 8: Transmitter/Translator RF Power Screen (BTD/BRD)
This is the default screen that is displayed after the splash screens are displayed. This screen
provides an indication of the Output Power of the system in terms of Percent. (Typically
100%). The screen also provides an indication of the Reflected Power of the system in terms
of Percent. (Typically less than 5%). Push the DOWN Arrow to view the next main menu,
which is the System Fault Log Main Menu.
Table 9: Transmitter/Translator Fault Log Main Screen (BTD/BRD)
This is the System Fault Log Main Screen. Push the ENTER button to access the Fault List
submenu or push the DOWN Arrow to view the next main menu, which is the System Details
Main Menu.
Table 9.1: Transmitter/Translator Fault List Screen (BTD/BRD)
If faults are present, they will be displayed on this screen. The above screen indicates
no faults have occurred in the System. Push the LEFT Arrow to exit to the System
Fault Log Main Menu screen.
Table 10: Transmitter/Translator Details Main Screen (BTD/BRD)
This is the System Details Main Screen. Push the ENTER button to access the Device Details
Chassis Values Main Sub Screen or push the DOWN Arrow to view the next main menu, which
is the System Set Up Main Menu.