User's Manual

Innovator CU5-1800BTD/BRD ATSC Transmitter/ Initial On Site
Regenerative Translator Turn On Procedure
Instruction Manual, Rev. 0 24
LCD Front Panel Screens
A LCD display, located on the front of the Innovator CXB Series systems, displays, on screens,
the current operating status of the system. When the tray is powered On, the LCD will
initially display two splash screens. The first splash screen will be displayed for a few
seconds, then the second splash screen will be displayed for a few seconds and finally the RF
Power Display default screen will be displayed. See examples of the screens below. The RF
Power Display default screen will be the screen displayed if no buttons are pushed to access
other screens. While viewing the RF Power Display default screen, pushing the Left and Right
arrow buttons together will also access the splash screens.
Splash Screen Number 1
The first splash screen displayed indicates the manufacturer, type and the model number.
Splash Screen Number 2
The second splash screen indicates the Firmware and Version Numbers of the software used
in the system. The example shown is Firmware number 1312423 Version number 4.0f/1.F.
The final screen is the RF Power default screen which indicates the Forward Power and
Reflected Power for the system.
The following screens are scrolled through using the buttons to the right of the display. Pushing
and releasing the Up & Down Arrows will scroll you through the Main Menus, which are shown
on the following pages aligned on the left side of the page. The Submenus of the Main Menus
are accessed by pushing and releasing the ENTER button. Once in the Submenus, pushing and
releasing the Up & Down Arrows will scroll you through the submenus of the Submenus. The
Submenus are shown on the following pages indented under the Main Menus and the submenus
of the Submenus are indented under the Submenu in which they are contained. In the SET UP
Menus, changes are made to the display by Pushing and releasing the ENTER button which
causes the item to be changed to blink, then using the left and right arrow buttons to display
the desired changed item, finally, pushing the ENTER button will accept the changes made upon
exit of the Set Up Menu.
NOTE: An example of accessing and changing an item using the Set Up Menus is as follows.
This procedure is to set the Off Air Receive Channel to the desired channel. Push and
release the DOWN Arrow button until the SYSTEM SET UP Main Menu is displayed.
Push and release the ENTER button. The Authorization Warning screen is displayed.
Left/Right Buttons
Enter Button
Up/Down Butt
ons