User's Manual

Innovator CU5-1800BTD/BRD ATSC Transmitter/ Web Ethernet
Regenerative Translator Interface Description
Instruction Manual, Rev. 0 38
(Optional) Innovator CXB Series Web Ethernet Interface
The (Optional) Innovator CXB Series Web Ethernet Interface (1310183) allows for the
monitoring and control of the Innovator CXB Series system without the need for special
software on the remote computer. This option may not be included in your system.
Figure 7: Typical Ethernet Configuration Menu
For the first time configuration of the system, the following must be completed. A
computer must be placed on the same LAN as the Innovator CXB Series system (NOTE:
The Innovator CXB does not serve DHCP addresses – they must be entered manually on
the setup computer), which has the following factory default settings. Refer to Figure 7
for a typical configuration screen. (NOTE: A crossover cable may be needed if
connecting directly from a computer to the Innovator CXB Series system).
IP address: 192.168.0.1
Subnet Mask: 255.255.255.000
Default Gateway: 10.0.0.1
Once a connection has been established, the web interface can be launched by entering
the IP address of the Innovator CXB Series system as a URL in the browser of the
remote computer. A login screen will be displayed prompting for a user name and
password, which are case sensitive. There are two levels of access: administrative
and view only. The factory default user name and password is:
User name: admin
Password: axcera