User's Manual

Innovator CU0TD-1/CU0RD-1 – CU4TD/CU4RD Initial On Site
ATSC Transmitter/Regenerative Translator Turn On Procedure
Instruction Manual, Rev. 1 43
Table 11.1.4: Chassis Values Latch On an Input Fault Set Up Screen (TD/RD)
This screen, by selecting ON, allows the user to select that the system will
latch the fault if it occurs, then if the problem is corrected the fault will still
register. Since latched faults are used to set the status LED color, when fault
latching is OFF, the status LED should only be green if there are no faults or
red if there are one or more active faults. When fault latching is ON, the
status LED will be amber if there are no current faults but a fault was
previously detected and is now a latched fault. A blinking amber status LED
indicates that there are no current faults or latched faults but that an internal
signal source is selected instead of an external source.
Table 11.1.5: Chassis Values IF Processor Selection Screen (TD/RD)
This screen allows the user to select that the system has an IF Processor.
Table 11.1.6: Chassis Values Downconverter Selection Screen (TD/RD)
This screen allows the user to select that the system has a Downconverter.
Table 11.1.7: Chassis Values Amplifier Power Supply Voltage Screen (TD/RD)
This screen allows the user to select the Power Supply Voltage.
Table 11.1.8: Chassis Values Forward Power Fault Adjust Screen (TD/RD)
This screen allows the operator to configure a forward power fault threshold
setting. When the exciter is enabled for at least a few seconds and the
system forward power is not greater than or equal to this setting, a fault is
indicated on the status LED and also on the remote fault indicator pin.
Table 11.1.9: Chassis Values number of Amplifiers in System Screen (TD/RD)
This screen indicates the number of external amplifier drawers in the system.
By selecting the enter key, the system will scan to find the number of
external amplifier drawers. NOTE: Do not change this screen without first
consulting with Axcera.
Table 11.1.10: Chassis Values Ethernet Option Set Up Screen (TD/RD)
Only displayed if Ethernet Controller is not present in your system.