User's Manual

Innovator CU0TD-1/CU0RD-1 – CU4TD/CU4RD Initial On Site
ATSC Transmitter/Regenerative Translator Turn On Procedure
Instruction Manual, Rev. 1 33
Splash Screen Number 1
The first splash screen displayed indicates the manufacturer, type of transmitter and the
model number.
Splash Screen Number 2
The second splash screen indicates the Firmware and Version Numbers of the software used
in the system. The example shown is Firmware number 1312423: Version number 6.3/2.7.
The final screen is the RF Power default screen which indicates the Forward Power and
Reflected Power for the system.
The following screens are scrolled through using the buttons to the right of the display.
Pushing and releasing the Up & Down Arrows will scroll you through the Main Menus, which
are shown on the following pages aligned on the left side of the page. The Submenus of the
Main Menus are accessed by pushing and releasing the ENTER button. Once in the
Submenus, pushing and releasing the Up & Down Arrows will scroll you through the
submenus of the Submenus. The Submenus are shown on the following pages indented
under the Main Menus and the submenus of the Submenus are indented under the Submenu
in which they are contained. In the SET UP Menus, changes are made to the display by
Pushing and releasing the ENTER button which causes the item to be changed to blink, then
using the left and right arrow buttons to display the desired changed item, finally, pushing the
ENTER button will accept the changes made upon exit of the Set Up Menu.
NOTE: An example of accessing and changing an item using the Set Up Menus is as follows.
This procedure is to set the Off Air Receive Channel to the desired channel. Push
and release the DOWN Arrow button until the SYSTEM SET UP Main Menu is
displayed. Push and release the ENTER button. The Authorization Warning screen is
displayed. Push and release the ENTER button again and the ENTER BUTTON SETS
TO CHANGE MODE screen is displayed. Push and release the ENTER button again
and the first set up menu, which is the SET UP MENUS OF CHASSIS VALUES screen
is displayed. Push and release the DOWN Arrow button until the SET UP 8VSB
DEMODULATOR screen is displayed. Push and release the ENTER button to display
the submenus under the SET UP 8VSB DEMODULATOR menu. Push and release the
DOWN Arrow until the 8VSB DEMODULATOR USE OFF AIR CHxx is displayed. Push
and release the ENTER button and the XX, which indicates the Channel Number, will
blink. Push and release the UP or DOWN Arrow button until the desired new channel
number is displayed. Push and release the ENTER button, and the PUSH ENTER TO
ACCEPT CHANGES menu is displayed. Push and release the ENTER button again to
Left/Right Buttons
Ente
r Button
Up/Down Buttons