Manualshelf

User's Manual

ManualsBrandsUBS-Axcera ManualsElectronics200 Watt UHF Digital Transmitter
21222324252627282930
Innovator CU0TD-1/CU0RD-1 – CU4TD/CU4RD Unpacking, Installation &
ATSC Transmitter/Regenerative Translator Maintenance
Instruction Manual, Rev. 1 17
Unpacking, Installation and Maintenance
Unpacking
Axcera certifies that upon leaving our facility all equipment was undamaged and in proper
working order. It is imperative that all packages be inspected immediately upon arrival to
verify that no damage occurred in transit to the site. Inspect all packages for exterior
damage and make note of any dents, broken seals, or other indications of improper
handling. Carefully open each package and inspect the contents for damage. Verify that
all materials are enclosed as listed on the packing slip. Report any shortages to Axcera.
In the event any in transit damage is discovered, report it to the carrier. Axcera is not
responsible for damage caused by the carrier. If the equipment is not going to be
installed immediately, return all items to their original packaging for safe storage. Save
all packing material for future use. If equipment is ever removed from the site, the
original packaging will ensure its safe transport.
Figure 1: CU2TD Front View Typical Racking Plan
Installation
The Innovator CX Series transmitters are designed for simple installation. Expensive test
equipment is not required for installation and set up and to keep a system operational. An
information decal, with Voltage Range, Current Range, Manufacturer, Model and ratings is
attached to the rear panel of the stand alone drawer or if mounted in a cabinet, to the top
of the frame above the door facing the rear of the cabinet. Prior to installing the product,
review the following items. Check that they been installed, tested and/or inspected.
Building Structure
Electrical Systems
Heating and Air Conditioning
Receive Antenna or Satellite Dish and input cabling
Optional ASI to S310 Converter, if needed
Transmit Antenna and output transmission line
A1
Exciter/Driver
A2
Power Amplifier
A3
Power Amplifier
The (Optional) UPS is
located behind this blank
panel