User's Manual

Innovator CU0TD-1/CU0RD-1 – CU4TD/CU4RD ATSC Initial On Site
Transmitter/Regenerative Translator Turn On Procedure
Instruction Manual, Rev. 2 92
Figure 53.1.6: AGC Details Screen
This menu indicates if the AGC circuit has an input. An AGC input fault
indicates that there is no RF input to the board, which could occur if anything
before it fails.
Figure 53.1.7: AGC Overdrive Details Screen
This menu indicates if the AGC circuit is operating within its range.
Figure 53.1.8: AGC Auto/Manual Details Screen
This menu indicates if the AGC circuit is operating in Auto or Manual.
Figure 53.1.9: ALC Voltage Level Details Screen
This menu indicates the Auto ALC voltage setting, typically 1 to 5 V.
Figure 53.2: Modulator Device Details Screen
This is the Transmitter Device Details Modulator Main Sub Screen. Push the ENTER
button to access the Device Modulator submenus. Push the DOWN Arrow to view the
next main submenu, which is the Upconverter Sub Menu. Push the LEFT Arrow to go
back the Main Device Details Screen. Then push the DOWN Arrow to access the
Transmitter Set -Up Main Menu.
Figure 53.2.1: Digital Modulator Identification Screen
This menu provides access to screens that display the Modulator's Date and
Time or the Modulator's Site ID.
Figure 53.2.1.1: Digital Modulator Time Set Date Set Screen
This Screen displays the Modulator's date and time to allow
confirmation that the communications system between the Innovator
CX and the Digital Modulator is operational. Adjustments to the date
and time are available through the Digital Modulator's web pages.
Figure 53.2.1.2: Digital Modulator Site ID Set Screen
This Screen displays the Digital Modulator's Site ID which confirms
that the communications system between the Innovator CX and the
Modulator is operational. Adjustment to the Site ID is available
through the Modulator's web pages.