User's Manual

Innovator CU0TD-1/CU0RD-1 – CU4TD/CU4RD 8VSB ATSC Modulator
ATSC Transmitter/Regenerative Translator
Instruction Manual, Rev. 2 75
8VSB ATSC Parameters
The ATSC parameter table lists the menus items and associated parameters available
from the modulator interfaces. The main menu (or top level) items are capitalized and
bolded. The subsequent sub-menus (Level 1 and Level 2) are listed below.
The numbered menu items and parameters are a reflection of the numbers the user will
see when accessing the modulator CLI.
2. CONFIG
Level 1 Level 2 Parameter Selection Notes
1. Modulator
Mode
0. Normal
1. CW
1. MH Enable 0. OFF
1. ON
2. SFN 0. OFF
1. ON
3. Config from TCP 0. ON
1. OFF
4. Transmitter ID Range: 0 .. 4095
5. OM_type Range: 0 .. 255
6. Local DelayOffset Range: -3276.8 to
3276.7 µsec
7. Net Id Pattern Range: 0 .. 4095
8. Tx Id Level Range: 0 .. 7
2. Transmission
9. Transmitter Power Range: 0 .. 4095
SFN Mode
Only
3. Input 0. ASI A
1. ASI B
2. SMPTE310 A
3. SMPTE310 B
4. Auto
SMPTE310 A
and B are
only
selectable
when unit is
equipped with
this type of
input
1. Mute ON/OFF 0. OFF
1. ON
2. Spectrum Inversion 0. OFF
1. ON
3. Shaping Filter 0. Narrow
1. Wide
4. RF Power Level Range: -10.0 ..
0.0 dBm
(0 to+10 dBm
optional)
4. Output
5. RF Output Frequency Range: 470000000 ..
1000000000 Hz
5. RF Channels 1. CH 2 (57 MHz) to
50. CH 51 (695 MHz)
Configured
frequency
range is
supported
1. NLP State 0. OFF
1. ON
6. Non-Linear
Pre-corrector
2. NLP Profile 0 .. 9