User's Manual

Innovator CU0TD-1/CU0RD-1 – CU4TD/CU4RD 8VSB ATSC Modulator
ATSC Transmitter/Regenerative Translator
Instruction Manual, Rev. 2 69
CLI (Command Line Interface)
Introduction
The modulator can be controlled and monitored from the Command Line Interface (CLI)
in addition to the Web GUI.
The CLI is accessible from the USB port via a HyperTerminal session or from the
Ethernet port via Telnet or HyperTerminal sessions.
Using the USB Port to Access the CLI
The modulator must be connected to a laptop PC using a USB-to-USB cable. The cable
will require a USB Type B connector to mate with the modulator USB port, while the
other connector has to mate with the laptop PC USB port.
Open a HyperTerminal (or HyperACCESS depending on the operating system) session on
the laptop PC and set the parameters as shown below.
Figure 43: Com Settings