User's Manual

Innovator CU0TD-1/CU0RD-1 – CU4TD/CU4RD ATSC System Set-up
Transmitter/Regenerative Translator Procedure
Instruction Manual, Rev. 2 125
Figure 65: (A5) Amplifier Control Board (1309822)
Linearity Correction Adjustment (Non-Linear Distortions)
NOTE: See the separate Digital Pre-Corrector GUI Software Instruction Manual for
information on the setting up of the Non-Linear Distortions pre-correction.
Linearity Correction Adjustment (Linear Distortions)
NOTE: See the separate Digital Pre-Corrector GUI Software Instruction Manual for
information on the setting up of the Linear Distortions pre-correction.
NOTE: If the system contains the 8VSB ATSC Modulator board, any correction
adjustments are done using the Modulator board. Refer to the sections of this manual
on the Modulator board for information on the procedure.
If a problem occurred during the set up, help can be found by calling UBS-Axcera field
support at 1-724-873-8100.