User's Manual

Innovator CU0TD-1/CU0RD-1 – CU4TD/CU4RD ATSC Initial On Site
Transmitter/Regenerative Translator Turn On Procedure
Instruction Manual, Rev. 2 99
Figure 54.2.2: Modulator Secondary Input Selection Set-Up Screen
This screen allows the user to select a secondary input source to the
modulator.
Figure 54.2.3: Modulator Linear Equalization Selection Screen
This screen controls the operation of the linear equalizer. When set to ON,
the modulator applies linear correction to the IF output. When set to OFF, no
correction is applied to the IF.
Figure 54.2.4: Modulator Non Linear Equalization Selection Screen
This screen controls the operation of the non linear equalizer. When set to
ON, the modulator applies non linear correction to the IF output. When set to
OFF, no correction is applied to the IF.
Figure 54.2.5: Modulator Values IP Address Set-Up Screen
This screen is used to view or change the IP Address of the modulator.
Figure 54.2.6: Modulator Values IP Netmask Set-Up Screen
This screen is used to view or change the IP subnet mask of the Modulator.
Figure 54.2.7: Modulator Values IP Gateway Set-Up Screen
This screen is used to view or change the IP gateway (router) address of the
Modulator.
This is the final screen in the Transmitter Set-Up Modulator Main Sub Screens. Push
the down arrow to repeat the Modulator Main Sub Screens or Push the LEFT Arrow to
go back the Modulator Main Set-Up Screen.