User's Manual

Innovator CU0TD-1/CU0RD-1 – CU4TD/CU4RD ATSC Initial On Site
Transmitter/Regenerative Translator Turn On Procedure
Instruction Manual, Rev. 2 95
Figure 53.4.9: External Amplifier #1 A Temperature Details Screen
Indicates the temperature of heatsink A in the external amplifier #1. NOTE:
Typical temperature for DVB = ≈20-30°C above ambient.
Figure 53.4.10: External Amplifier#1 B Temperature Details Screen
Indicates the temperature of heatsink B in the external amplifier #1. NOTE:
Typical temperature for DVB = ≈20-30°C above ambient.
Figure 53.4.11: External Amplifier #1 Code Version Details Screen
Indicates the code version in the external amplifier #
Set- Up Screens
Figure 54: Transmitter Set-Up Main Screen
This is the Transmitter Set-Up Main Screen. Push the ENTER button to access the
Authorization Warning Main Sub Screen. This is the final Main Screen, pushing the DOWN
Arrow will take you back to Transmitter Details Main Menu.
The Set-Up item or parameter that can be changed on the displayed sub menu screen, is
indicated by pushing the ENTER button, which causes the changeable item to blink. The UP
or DOWN arrow will change the selection until the desired result is displayed. Pushing the
ENTER Button will accept the change.
Figure 54A: Authorized Personnel Screen
This screen of the transmitter notifies an operator that they are only to proceed if they
are authorized to make changes to the transmitter's operation. Changes made within
the following set-up screens can affect the transmitter’s output power level, output
frequency, and the general behavior of the transmitter. Please do not make changes
within the transmitter's set-up screens unless you are familiar with the operation of the
transmitter. Pressing the ENTER button will display the Enter Key Sets to Change screen.
Figure 54B: Right Key Sets to Change Mode Screen
This screen informs the operator that to make changes, the Right key or the Enter key
must be pushed, which will cause the display that can be changed to blink. Use the up
or down key to change the display and the left or right key to move the blinking item on
the display. After changes are made in the Set-Up Menus pushing the enter Key,
Button, will accept the changes made. With the Right Key Sets To Change Mode screen
displayed, pushing the ENTER button will access the first main submenu under the Set-
Up main menu, which is the Chassis Values Set-Up Menu.