User's Manual

Innovator CU0TD-1/CU0RD-1 – CU4TD/CU4RD ATSC Initial On Site
Transmitter/Regenerative Translator Turn On Procedure
Instruction Manual, Rev. 2 93
Figure 53.2.2: Digital Modulator Signal Status Screen
This menu provides access to screens that display the status of the Digital
Modulator's signals. As these are detail screens, they are read only and not
adjustable. They provide basic feedback on the configuration of the Digital
Modulator. Configuration is completed through the Modulator's web pages.
Figure 53.2.2.1: Digital Modulator Primary Path A Set Screen
This Screen indicates the status of the Primary Input Path A.
Configuration is completed through the Digital Modulator's web pages.
Figure 53.2.2.2: Digital Modulator Secondary Path B Set Screen
This Screen indicates the status of the Secondary Input Path B.
Configuration is completed through the Digital Modulator's web pages.
Figure 53.3: Upconverter Device Details Screen
This is the Transmitter Device Details Upconverter Main Sub Screen. Push the
ENTER button to access the Device Upconverter submenus. This is the final Device
Details Main Sub Menu. Push the LEFT Arrow to go back the Main Device Details
Screen. Then push the DOWN Arrow to access the Transmitter Set-Up Main Menu.
Figure 53.3.1: Upconverter 10 MHz Details Screen
This menu indicates if the 10 MHz reference used is generated internally or
provided by an external reference source, such as a GPS.
Figure 53.3.2: Upconverter Transmitter Channel Details Screen
The upconverter transmit channel screen indicates the channel that the
upconverter is currently set and the center frequency of that channel.
Displayed above is CH: 47 that has a Center Frequency of 671MHz.
Figure 53.4: External Amplifier Device Details Screen
This is the Transmitter Device Details External Amplifier Main Sub Screen. This is
the final Device Details Main Sub Menu. Push the ENTER button to access the Device
External Amplifier #1. Push the LEFT Arrow to go back the Main Device Details
Screen. Then push the DOWN Arrow to access the Transmitter Set-Up Main Menu.
NOTE: Shown below are the External Amplifier #1 Details Screens. The External Amplifier
#2, #3 or #4 Details Screens are presented in the same order if they are present in the
system.