Manualshelf

User's Manual Part 2

ManualsBrandsUBS-Axcera ManualsElectronics400-Watt, 1.6 GHz DVB-H Transmitter
31323334353637383940
CL1TC-4 400W DVB-H Transmitter Modulator Front Panel
Product Manual, Rev. 1 108
Status Display d - this window displays the software versions as seen below:
----------------------------------------
DVB-TH FPGA: 5889 CPLD: 40
Kern: 3037 Soft: 2376 d
----------------------------------------
Status Display e - this window displays the active alarms as seen below:
----------------------------------------
Alarms: 2 alarms
No Input Data e
----------------------------------------
If more than one alarm is active, this window will automatically be updated, every few
seconds, to display one alarm at a time.
Status Display f - This window displays the following network management settings:
----------------------------------------
Management IP: 172.20.33.175
Management Netmask: 255.255.0.0 f
----------------------------------------
Status Display g - this window displays the following modulator settings:
----------------------------------------
UPConv RF Lev: 0.0
g
----------------------------------------
Status Display h - this window displays the following modulator mode settings:
----------------------------------------
Modulator Mode: Normal
Playback File: None h
----------------------------------------
Status Display i – this window displays the following transmitter RF parameters:
----------------------------------------
HPA Forward RF Level: 56.02
Reflected RF Level: 30.80 i
----------------------------------------
8.5
Config Menu Displays
From any o
f the status displays the user can navigate to the Config menu system. From a
status screen press the right f button on the front panel. The following display will appear:
----------------------------------------
Entering the GENERIC Config. Menu
Press EXECUTE to Continue...
----------------------------------------
Press the EXECUTE button on the front panel to enter the Config Menu.
To return to the status display, press the up c button on the front panel interface. You may
need to press the up c button multiple times depending on how deep the user is located in
the sub-menu chain.