User's Manual Part 2
CL1TC-4 400W DVB-H Transmitter Modulator Front Panel
Product Manual, Rev. 1 105
Example E
----------------------------------------
Web Password = admin
admin
----------------------------------------
8.2.2 Configuring Parameters
8.2.2.1 Selection of Enumerated Values
----------------------------------------
Modulator Mode = Normal
[Normal] CW Test 1(Carriers Removal...
----------------------------------------
(the square brackets flash at approx. 2 Hz)
The current value is shown as the first item in the list, in square brackets.
Navigating:
w Scrolls the previous item into the “current position”.
8 Scrolls the next item into the “current position”.
6 No effect.
5 Aborts editing and returns to the previous menu level.
<EXECUTE> Saves the “current” item as the active parameter and returns to the previous
menu level.
8.2.2.2 Editing a Numeric Value
----------------------------------------
RF Output Frequency = 1670000000
1670000000 [167000000..1675000000]
----------------------------------------
(the character 0 alternates between ‘0’ and ‘_’ at approximately 2 Hz)
The configurable value that appears on the display is always the current value and the cursor is initially
positioned on the last digit. The valid range is displayed in square brackets on the right hand side of the
bottom line.
Navigating:
w Positions the cursor on the previous character or moves to the last character when
the cursor is on the first character.
8 Positions the cursor on the next character or moves to the first character when the
cursor is on the last character.
6 Decrements the value of the highlighted character. If the character value is ‘0’, the
button will change the value to ‘9’. If the parameter can be set to a negative
number, the button will toggle between a negative sign (-) and a blank (positive)
when the first character is highlighted.
5 Increments the value of the highlighted character. If the character value is ‘9’, the 5
button will change the value to ‘0’. If the parameter can be set to a negative
number, the 5 button will toggle between a negative sign (-) and a blank (positive)
when the first character is highlighted.