User's Manual Part 2

CL1TC-4 400W DVB-H Transmitter WEB Interface
Product Manual, Rev. 1 74
6.5.1 Alarm Properties
The fi
rst item in the Alarm Properties page is the Alarm Index. The Alarm Index box has a
pull-down menu permitting the user to select a specific alarm from the list for configuration.
The list of alarms along with a description of each alarm can be found in Section 10
.
The user can configure each alarm to be displayed (Alarm Enabled ON) or ignored (Alarm
Enabled OFF) and can configure the modulator to send an SNMP trap for any active alarm.
The user can also configure a number of relays on the modulator rear panel to be triggered
on alarm.
The integration time can be set to any value between 0 to 360 seconds, allowing the
modulator to avoid reporting intermittent alarms. An alarm will only be reported if it is still
active after the integration time has elapsed.
The Alarm Properties page also summarizes the current Alarm Properties settings for all
system alarms under Alarm Property Setting Summary.
Figure 6-26 Alarm Properties Configuration