User's Manual Part 2

CL1TC-4 400W DVB-H Transmitter CLI
Product Manual, Rev. 1 90
7.3 Using Ethernet Port to access the CLI
The modula
tor can be connected directly to a PC or through a hub/switch using an RJ-45
straight-through cable.
The modulator and PC must be configured to be on the same IP network so that a
connection can be established.
A Telnet client can be opened from the “Start/Run” button on the PC. Enter the IP address
assigned to the modulator followed by the number 26 – see below.
Figure 7-2 Starting the Telnet session
A HyperTerminal session can also be used to access the CLI through the Ethernet port – see
Figure 7-1
.
7.4 CLI Login Procedure
1. Once t
he connection has been established, press enter to get to the login prompt.
2. Enter the password and press enter. NOTE: The password is “admin” by default, but
can be changed through the Web GUI, CLI or SNMP.
3. After the password has been verified, the main menu will appear.
Figure 7-3 Telnet Login Prompt