User's Manual Part 2

CL1TC-4 400W DVB-H Transmitter CLI
Product Manual, Rev. 1 89
7 Command Line Interface (CLI)
7.1 Introduction
The tra
nsmitter can be controlled and monitored from the Command Line Interface (CLI) in
addition to the Web GUI and front panel.
The CLI is accessible from the USB port or via a Telnet session through the Ethernet
management port.
7.2 Using the USB Port to access the CLI
The modula
tor must be connected to a PC using a USB-to-USB cable. The cable will require
a USB Type B connector to mate with the modulator USB port, while the other connector
has to mate with the PC USB port.
Open a Hyperterminal (or HyperACCESS depending on the operating system) session on the
PC and set the parameters as shown below:
Figure 7-1 COM settings