User's Manual Part 1

CL1TC-4 400W DVB-H Transmitter WEB Interface
Product Manual, Rev. 1 70
6.4.9 HPA Control
The HPA
Control page contains a drop down menu that allows the user to set the
transmitter to one of the following modes:
• Standby
• Broadcast
• Manual
Broadcast mode represents normal operation. Standby mode disables the transmitter
output. In Manual mode the HPA behaves as a simple amplifier and the modulator control
of the HPA output is limited to setting the input drive level to the HPA.
The RF Output Power Level allows the user to set the output power level to a value between
46 dBm and 56 dBm.
Figure 6-22 HPA Control Configuration
The available parameters are:
Item Selection
RF Output Power Level Range: 46.00 .. 56.00 dBm
Transmitter Operating Mode Standby, Broadcast, Manual
Table 6-9 Non-Linear Pre-corrector Parameters