User's Manual Part 1

CL1TC-4 400W DVB-H Transmitter WEB Interface
Product Manual, Rev. 1 53
6.3.1 Global Status
The Global status
page appears upon login and provides general information about
parameter settings and the transmitter’s alarm status. The list of parameters will change
dynamically as the transmission mode (MFN or SFN) and/or transport stream input (ASI or
IP) is changed. See Figure 6-2
, Figure 6-5 and Figure 6-6 for details.
The drop down menus, located at the top of the status page, provide links to other pages
that control various parameters and alarm functions.
• Versions and Serial Numbers: Displays the software and firmware version number
for each of the main software components of the modulator.
• HPA Statuses: Displays the Transmitter Operating Mode (Broadcast, Standby or
Manual) Input, Forward and Reflected RF power levels for the HPA as well as the
Cabinet Ambient Temperature.
• Modulator Type: Displays the modulator waveform selected (DVB-T/H).
• Transmission: Displays the Modulator Mode (Normal or CW), the SFN status (ON
or OFF), the OFDM parameter settings and the Ideal Bit Rate. The statuses of the
MIP offset functions are only displayed when SFN mode is enabled.
• SFN Parameters: Displays the Transmitter ID, the Local Delay Offset set by the
user, the MIP Maximum delay and MIP Time offset as included in the MIP and the
resulting Adjusted SFN Delay. This window is only available when SFN mode is
enabled.
• Input: Displays the Selected Input (Auto, A, B or IP), Input Status (Locked or
Unlocked) and the status of the 10 MHz and 1PPS Reference inputs.
• IP Input: Displays the IP Input status, Input Stream Destination IP Address and
Port, Buffer Depth, Packet Size, FEC Mode, Input Bit Rate and Packet information.
This window is only available when an IP input has been selected.
• Output: Displays the Bandwidth, RF Output Frequency, RF Output Power Level,
Spectrum Inversion (ON or OFF), parameters related to the pre-defined and User
Channel Grids (not uses for this application) as well as MIP parameters.
The Mute setting (ON or OFF) and Mute status (Muted or Unmuted) are also
displayed. The output might be muted as a result of an active alarm, even though
the Mute setting is set to OFF.
• External Board: Displays the voltage on each of the I/O port pins.
• Non-Linear Pre-corrector: Displays the status of the Non-linear Pre-corrector.
• Linear Pre-corrector: Displays the status of the Linear Pre-corrector.
• Network: Displays the modulator IP Addresses, Default Gateway and the
Management Netmask.
•
Ethernet Interface Status:
Displays the link status and speed.
• Alarms: Displays the number of active alarms