User's Manual

Innovator CHV400BTD ATSC Transmitter Web Ethernet
Interface Description
Technical Manual, Rev. 0 42
Figure 9: Typical Ethernet Main Control/Monitoring Screen
After logging in, the main control/monitoring screen is displayed, allowing operate and
standby control and read back of the system parameters. Refer to Figure 9 for a typical
main control/monitoring screen.
Green = okay/normal operation
Yellow = warning, no fault
Red = current fault
Orange = latched fault
To change the web interface settings, click the ‘configure’ button near the top of the
screen while you are logged as an administrator. When entering a site ID be sure to not
use special characters except underscores, dashes, and forward slashes.
If the item on screen is Orange, which indicates latched fault, the fault can be reset by
pushing the Fault Reset button located top middle of screen.
To manage user accounts, click the ‘Account Management’ button near the top of the
configure screen
NOTES: If your system contains the optional DVB Universal Modulator Board, the
Modulator Status button is displayed at the top left of the screen, under the Operate
Standby buttons. When this button is selected, a separate window opens in which
various screens are accessed for the monitor and control of the Universal Modulator.
Information on the WEB interface of the DVB Universal Modulator Board is contained in
Chapter 3 of the separate Universal Modulator Instruction Manual.