User's Manual

Innovator CHV400BTD ATSC Transmitter Initial On Site
Turn On Procedure
Technical Manual, Rev. 0 31
Set Up Screens
Table 11: Transmitter/Translator Set Up Main Screen (BTD/BRD)
This is the System Set Up Main Screen. Push the ENTER button to access the Authorization
Warning Main Sub Screen or since this is the final Main Screen, pushing the DOWN Arrow will
take you back to the System RF Power Default Screen.
The Set Up item or parameter that can be changed on the displayed sub menu screen, is
indicated by pushing the ENTER button, which causes the changeable item to blink. The UP
or DOWN arrow will change the selection until the desired result is displayed. Pushing the
ENTER Button will accept the change.
Table 11A: Authorized Personnel Screen (BTD/BRD)
This screen of the system notifies an operator that they are only to proceed if they are
authorized to make changes to the system's operation. Changes made within the
following set-up screens can affect the system’s output power level, output frequency, and
the general behavior of the system. Please do not make changes within the system's set-
up screens unless you are familiar with the operation of the system. Pressing the ENTER
button will display the Enter Key Sets to Change screen.
Table 11B: Enter Key Sets to Change Mode Screen (BTD/BRD)
This screen informs the operator that to make changes, the Enter key or the Right key
must be pushed, which will cause the display that can be changed to blink. Use the up or
down key to change the display and the left or right key to move the blinking item on the
display. After changes are made in the Set Up Menus pushing the enter Key, Button, will
accept the changes made. With the Right Key Sets To Change Mode screen displayed,
pushing the ENTER button will access the first main submenu under the Set Up main
menu, which is the Chassis Values Set Up Menu.
Table 11.1: Chassis Values Main Set Up Menu Screen (BTD/BRD)
This is the System Set Up Chassis Values Main Sub Screen. Push the ENTER button to
access the Chassis Values submenus or push the DOWN Arrow to view the next Set Up
Main Sub Screen, which is the Set Up 8VSB Demodulator Main Sub Screen. NOTE:
Refer to the description in Table 11B for how to change the values on the following
set-up screens.
Table 11.1.1: Chassis Values Forward Power Set Up Screen (BTD/BRD)
Remote or front panel adjustment of the output power of the transmitter. The
bar graph indicates the range remaining in the adjustment.