User's Manual

Innovator CHV400BTD ATSC Transmitter Initial On Site
Turn On Procedure
Technical Manual, Rev. 0 24
The following screens are typical of an operating system. The values indicated on the screens
in your system may vary from those shown below.
Operation Screens
NOTE: The following Operation screens provide operating information only. No adjustments
are available using these screens.
Table 8: Transmitter/Translator RF Power Screen (BTD/BRD)
This is the default screen that is displayed after the splash screens are displayed. This screen
provides an indication of the Forward Output Power of the system in terms of Percent.
(Typically 100%). The screen also provides an indication of the Reflected Power of the
system in terms of Percent. (Typically less than 5%). Push the DOWN Arrow to view the next
main menu, which is the Transmitter Event Log Main Menu.
Table 9: Transmitter/Translator Event Log Main Screen (BTD/BRD)
This is the Transmitter Event Log Main Screen. Push the ENTER button to access the Event
List submenu. Push the DOWN Arrow to view the next main menu, which is the Transmitter
Details Main Menu.
Table 9.1: Transmitter/Translator Event List Screen (BTD/BRD)
When events occur, they will be displayed on this screen. The Up and Down arrow will
page you through the different entries in the event log. The above screen indicates
the 001 event of 013 total events that have occurred in the Transmitter. The number
in the parenthesis on the top right, is this case 01, indicates the number of times the
displayed event has occurred. The bottom line scrolls to indicate the event that
occurred, in this case RF Interlock Fault, and the time the event occurred after the
prior event. Push the LEFT Key to exit to the Transmitter Event Log Main Menu
screen. Pushing the RIGHT Key will access the Event Reset Screen.
Table 9.2: Transmitter/Translator Event Reset Screen (BTD/BRD)
This screen allows the resetting of events, after they are observed or corrected.
NOTE: Resetting the events on an amplifier may cause the transmitter to momentarily
mute.
Table 10: Transmitter/Translator Details Main Screen (BTD/BRD)
This is the System Details Main Screen. Push the ENTER button to access the Device Details
Chassis Values Main Sub Screen or push the DOWN Arrow to view the next main menu, which
is the System Set Up Main Menu.