Assembly Instructions Chapter 3

4-6 kW UHF Translator Chapter 3, Installation and Setup Procedures
837B, Rev. 0 3-10
If the Translator is already connected
to the Antenna, check that the
Combined Output is 100%. If needed,
adjust the Power Adjust Pot located on
the UHF Exciter for 100% in the
Combined Output position.
This completes the translator setup and
operation procedures for the 837B UHF
solid state translator. The translator
can now be operated normally.
If a problem occurred during the setup
and operation procedures, refer to
Chapter 5, Detailed Alignment
Procedures, of this manual for more
information.